Kitchen Remodeling in Tampa Bay

The kitchen is the one room in the house that gets used every single day, which is exactly why a half-done kitchen remodel is so hard to live with. We take a kitchen from tear-out to finished cabinets, counters and hardware as one continuous job, so you are not stuck for weeks with a plywood countertop and a hot plate on the dining table.

A lot of the kitchens we walk into around Brandon, Riverview and Seffner still have whatever the builder put in, or whatever was in the house in the 1960s and has never been touched since. Cabinets that were cheap when they went in, counters that show every knife mark, a layout that made sense on paper but never worked once anyone actually cooked in it. That's the kitchen we're built to fix.

What's included

Full kitchen tear-outs and demolition
Cabinet installation, stock or custom-fit
Countertops — templated and set to the real room
Backsplash and tile work
Layout changes, including opening a kitchen to the next room
Hardware, fixtures and finish work

Once the old kitchen comes out, we check what's behind the walls and under the floor before anything new goes in — a cabinet installed over an uneven floor or against an out-of-square wall never sits right, no matter how good the cabinet is. Rough-in for plumbing and electrical gets coordinated before the walls close back up, so a sink or an outlet doesn't end up in the wrong spot because it was an afterthought.

Cabinets get set level and plumb first, because everything after that — counters, backsplash, hardware — is measured off them. Countertops are templated to the actual room, not to a drawing, and finishes are sealed and set the way they're meant to hold up to daily cooking, not just to look good on install day.

How we work

Walk & measure

We look at the current kitchen and talk through what isn't working, then measure everything against what you actually want.

Tear out & check

The old kitchen comes out and we check the floor, walls and rough-in before anything new is installed.

Cabinets & counters

Cabinets go in level and plumb, then counters are templated and set to fit exactly.

Finish & detail

Backsplash, hardware and trim go in last, and we walk the finished kitchen with you before we call it done.

Common questions

How long will I be without a working kitchen?

It depends on how much of the kitchen is changing — a counter and cabinet swap is faster than a full layout change. We'll walk you through the real timeline before work starts, not a rough guess.

Can you move my sink or island to a different spot?

Yes — layout changes are part of what we do. We plan plumbing and electrical moves before the walls or floor close back up, so it's done once, not patched later.

Do you install appliances too?

We set the kitchen up to receive them — cabinets, counters and rough-in built to fit your appliances — and we can install standard ones as part of the job. Tell us what you're working with and we'll tell you what's included.